Brake line fitting

[Apu]

Good day,

I have scoured the web looking for a source for the metric nuts that go from the hard line to the rubber lines on my Series 2a build and I can't seem to come up with any leads. Does any one have anything they have used or an adapter they have built that gets this acomplished? Or is there a source for these nuts I have missed? Any assistance would be appreciated. Thank you

[mike.heathcote]

I haven't seen the fittings sold separately, either.  They usually come with the pipes. 

Are you referring to these flex lines?   
https://www.lrparts.net/rtc3386-rear-brake-hose-for-land-rover-series-short-wheel-base-up-to-1980-also-clutch-hose-for-land-rover-series-2a.html 

I get most of my brake parts from this site - decent prices, but check the delivery rate... it may be worth your while (and safer) to buy new hard lines while you're at it. 

[Apu]

Yes, those line have metric threads and need those goofy threaded nuts.
Thank you for the link, i'll scoure the site. You may be correct though. I may be buying a line kit.

[binch]

are you referring to these fittings?

https://www.automec.co.uk/products/stainless-steel-brake-pipe-fittings-metric?variant=13299752435735

I'm assuming you don't have the old pipes then....?

[Apu]

Yes! those are the ones.
The original piping was corroded very bad and I just kept wrecking the fittings trying to free them up.
Thank you for the link!

[binch]

PM sent with two more sources for these parts ;)