Text Only | Text with Attachments

Alberta Land Rover Enthusiasts Club Forum

General => Technical Discussions => Topic started by: dijansmith on March 06, 2023, 07:30 AM

Title: Chevy (250) 4.1L inline six in a Series swapping to a Chevy 292....
Post by: dijansmith on March 06, 2023, 07:30 AM
Well currently I have an inline (250hp) 4.1L L6 in my series station wagon and was curious if anyone has put an Chevy 292 in a series before. if so, can you use the same gear box adapter?
Title: Re: Chevy (250) 4.1L inline six in a Series swapping to a Chevy 292....
Post by: binch on March 07, 2023, 07:28 PM
Sounds like the engine "bumpydormobile" had in his dormobile before he went 200tdi ???
Title: Re: Chevy (250) 4.1L inline six in a Series swapping to a Chevy 292....
Post by: bumpydormobile on March 10, 2023, 04:21 PM
I had a Chev 250 c.i inline six and had a Scotty's adapter, not sure if the 292 is the same.
Bill, my motor went into an old 1960's Chev car, I can't remember the model...
Title: Re: Chevy (250) 4.1L inline six in a Series swapping to a Chevy 292....
Post by: dijansmith on March 13, 2023, 12:04 PM
Thank you guys the knowledge is appreciated.
Title: Re: Chevy (250) 4.1L inline six in a Series swapping to a Chevy 292....
Post by: Matt H on March 18, 2023, 08:58 AM
They have the same bell housing bolt pattern as the 230 & 250 sixes (and V8's).
The 292 was a truck only engine and had a taller deck and I think the fuel pump is on the opposite side compared with the smaller units.

Great engines.
Text Only | Text with Attachments