Text Only | Text with Attachments

Alberta Land Rover Enthusiasts Club Forum

General => Non Technical Discussion => Topic started by: Chris on May 12, 2026, 03:49 PM

Title: Radio holder
Post by: Chris on May 12, 2026, 03:49 PM
My cousin has 3D printed these radio holders, seems to fit any beofeng nicely, but I am sure it'll fit most handhelds. If you would like one let me know and I can bring some to the next dinner meet in Edmonton for June!
They are 5$ each to make them. Let me know!
Title: Re: Radio holder
Post by: JohnnyO on May 30, 2026, 08:07 AM
Great idea. I'd like to have the radio secured somewhere. Not sure if the visor on the old Defender could handle the jostling around tho. Would this work on the lip of the lower dash. It would appear to be about the same width - 24mm(https://uploads.tapatalk-cdn.com/20260530/8a5db3ea394705b9f5769c2864a9d598.jpg)


Sent from my iPhone using Tapatalk
Title: Re: Radio holder
Post by: Chris on June 03, 2026, 08:11 PM
Itll probably go over it, how deep is it? If its shallow I dont think it would hold if its only half on it?
I'll bring them to the next gathering and try it on someone's defender
Title: Re: Radio holder
Post by: JohnnyO on June 06, 2026, 07:36 AM
The tray is a good three and a half inches at the deepest part. (https://uploads.tapatalk-cdn.com/20260606/c93c55ec6eb0605f04eeabb2c781e245.jpg)


Sent from my iPhone using Tapatalk
Title: Re: Radio holder
Post by: Chris on June 08, 2026, 05:18 PM
Ok, if you DM me I can probably mail it to yea,  I think it should work
Title: Re: Radio holder
Post by: binch on June 11, 2026, 10:39 PM
This could work....can u bring one to the July gathering so I can look it over pls?
Title: Re: Radio holder
Post by: Chris on June 23, 2026, 07:46 PM
you got it sir, see you there
Text Only | Text with Attachments