Alberta Land Rover Enthusiasts Club Forum

General => Technical Discussions => Topic started by: pechanec on September 05, 2016, 09:08 PM

Title: D2 stalling issue
Post by: pechanec on September 05, 2016, 09:08 PM
My d2 did a couple passes thru a 2 foot deep puddle at some speed yesterday. Right after the engine would only idle but bog out if I tried to rev it up. It idled nice and smooth for a couple hours as I hoped to dry it out,but no change. Towed it home and today it will start right up,idle smooth for a few seconds then quit.restarts fine . Yes,it did inhale some water,but level was well below intake. Swapped out TP and MAF sensors checked fuel pump. Any suggestions?

Sent from my XP7700 using Tapatalk

Title: Re: D2 stalling issue
Post by: Cruzer on September 05, 2016, 10:22 PM
Could be bad plug wires arcing, start up at night see if you can notice any arcing.