Alberta Land Rover Enthusiasts Club Forum
General => Technical Discussions => Topic started by: binch on April 10, 2021, 12:02 AM
Hi gang,
I have a two parts (both the same) that I've taken off the RRC but do you think I can remember what they were for????? Can anyone out there tell me what this folded tin bracket is? the bolt is a 1/2" x 4" long. It's little difficult to see it but there are two small tabs near the top (right side of object) at opposite ends of the top of the 'T' piece. I'm thinking maybe, just maybe it was something off the front axle somewhere but i really don't know.
(https://live.staticflickr.com/65535/51107223825_cca76285e5_m.jpg)
Have you been working on the Bigfoot sighting team again? Could you try again with the object in focus?
LOL......I didn't want to make it too easy ;D Try these pics:
https://www.flickr.com/photos/alre_club/with/51108220635/ (https://www.flickr.com/photos/alre_club/with/51108220635/)
(https://live.staticflickr.com/65535/51107341948_593d4f6140_m.jpg)
(https://live.staticflickr.com/65535/51106867837_9298c44160_m.jpg)
(https://live.staticflickr.com/65535/51108220600_0648256563_m.jpg)
(https://live.staticflickr.com/65535/51107188174_afdafe5626_m.jpg)
(https://live.staticflickr.com/65535/51108220635_f917741e69_m.jpg)
(https://live.staticflickr.com/65535/51107447836_bfafa703e9_m.jpg)
It does not ring any bells with me.
What year is the RRC? Could be part of the axle vibration dampener as fitted to later Rangies?
Now that's a good question......there are three options....1990, 1991 or 1993. But I'm leaning toward the first 2.
Originally I was thinking they had something to do with the speedo gizmo that changes from a rotating cable to an electronic signal, located on the chassis near the gearbox.
AH HAH!!!!! I figured out what that danged part was!!!!
It's 1 of 2 brackets (MWC6938) that hold up the back of the engine tray under the RRC's engine. The bolts are long enough to go through the chassis. It's hard to say whether it ends at the center cross member.